Page 208 - Manual Oficina Polaris Sportsman 570 2014 a 2016
P. 208
ENGINE / COOLING SYSTEM
11. Torque new flywheel nut to specification. OIL PUMP ASSEMBLY
1. Clean and dry all parts thoroughly. Apply clean
engine oil to all parts. Do not use gasket sealer on
the pump cover mating surfaces.
2. Align the gerotor according to the orientation dots.
3. Place the drive pin e through the oil pump drive
shaft t.
TORQUE
Flywheel Retaining Nut:
133 ft-lbs (180 Nm)Torque to specification, back of
180 degrees, retorque to specification.
12. Install starter idler gear w and shaft q.
4. Slide the gerotor e onto the drive shaft and lock
them into position on the drive pin.
5. Install the washer u onto the drive shaft.
6. Install the oil pump cover onto the shaft assembly.
7. Grasp the complete oil pump assembly by the drive
shaft and install the assembly into the stator cover.
8. Pack the voids of gerotor and relief valve bore with
white lithium engine assembly grease (Lubriplate
#105 or equivalent).
9. Install the q oil pump cover bolts and torque to
specification.
TORQUE
Oil Pump Cover Bolts:
7 ft-lbs (10 Nm)
3.86 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.
