Page 86 - Manual Oficina Polaris Sportsman 570 2014 a 2016

MAINTENANCE

OIL AND FILTER CHANGE - 570 8. Replace sealing washer on drain plug.

Always change the oil and filter at the intervals outlined in NOTE
the Periodic Maintenance Chart. Always change the oil
filter whenever changing oil. The sealing surfaces on the drain plug and the oil tank
should be clean and free of burrs, nicks or scratches.
Oil Filter torque:
Lubricate seal with engine oil. Turn by hand until 9. Reinstall the drain plug and torque it to specification.
filter gasket contacts sealing surface, then turn an
additional 3/4 turn TORQUE
Oil Pan Drain Plug:
Oil Filter Wrench: 12 ft-lbs (16 Nm)
PU-50105
10. Place a drain pan under the oil filter.
Recommended Engine Oil:
11. Place shop towels beneath oil filter w. Use Oil Filter
Polaris PS–4
Wrench (PU-50105), turn filter counterclockwise to
Synthetic 5W-50
remove.
12. Using a clean dry cloth, clean filter sealing surface
CAUTION on the crankcase.
Personal injury can occur when handling used oil. Hot 13. Lubricate the o-ring on new filter with a thin film of
oil can cause burns or skin damage. engine oil. Check to make sure the O-ring is in good
condition.
NOTICE: Care must be taken to ensure that the fluids 14. Install the new filter and turn it by hand until the filter
are contained. Be prepared to collect the fluid with gasket contacts the sealing surface, then turn an
suitable containers before opening any compartment additional 3/4 of a turn.
or disassembly of any component containing fluids.
15. Remove dipstick.
1. Place vehicle on a level surface.
16. Add oil as necessary to bring the oil level to the
2. Place the transmission in PARK (P). upper mark on the dipstick. Do not over fill the
3. Clean area around drain plug at bottom of oil pan. engine, the maximum oil capacity is 2 qts(1.9 l).
4. Start the engine. Allow it to warm up at idle for two to NOTE
three minutes.
The dipstick must be screwed completely in to ensure
5. Stop the engine. accurate measurement.
6. Place a drain pan under the crank case.
17. Reinstall the upper fill cap (if removed) and tighten
7. Remove the drain plug q. Allow oil to drain the dipstick.
completely.
18. Place the transmission in PARK (P).
19. Verify that the transmission is still positioned in
PARK (P).
20. Start the engine. Allow it to idle for two minuets.

21. Stop the engine and check for leaks.
22. Check the oil level on the dipstick and add oil as
necessary to bring the level to the upper mark on the
dipstick.
23. Dispose of used filter and oil properly.

2.20 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.