Page 167 - Manual Oficina Polaris RS1 2018 e 2019

ENGINE / COOLING SYSTEM

6. Apply Polaris PS-4 engine oil to each rod bearing 12.Install matching rod cap on connecting rod with 3 digit
journal r and main bearing journal t of crankshaft. serial number stampings aligned w & e.

3

7. Loop cam chain y and oil pump drive chain i over
crankshaft sprockets. 13.Install new bolts s and tighten evenly until snug.
8. Apply Polaris PS-4 engine oil to the new crankshaft
oil seal u and install the seal on the PTO end of the
crankshaft.

14.Torque connecting rod bolts to specification.
TORQUE
9. Carefully lower the crankshaft into upper crankcase. Connecting Rod Bolts:
Guide connecting rods onto the rod journals of Step 1: 9 ft-lbs (12 Nm)Step 2: 22 ft-lb (30 Nm)Step
crankshaft as necessary. 3: Tighten add’n 90°

10.Adjust the PTO crankshaft seal so it rests properly in
the upper crankcase.
11. Clean bolt hole threads in connecting rod to remove
all oil.

9928689 - 2018 RZR RS1 Service Manual 3.81
© Copyright Polaris Industries Inc.