Page 299 - Manual Oficina Polaris RS1 2018 e 2019

TRANSMISSION

10.Lift up on the shift shaft rail s and move the rail 17.Remove the six screws retaining the pinion shaft
assembly rearward to allow the shift fork pins to be plate l.
removed from the shift drum d. Remove the shift
drum from the transmission housing.

NOTE
11. Remove the shift shaft and forks as an assembly. One screw is longer 1( and than the others and must be
12.Remove the rear output shaft assembly f by lifting put back in the correct location.
underneath the gear or by tapping the shaft from the
opposite side. 18.Remove the pinion shaft assembly 2).
13.Remove the idler gear assembly g.
19.Inspect all gear and shaft assemblies for damage. 6
20.Check the bearings for damage and that they are
easy to turn. Replace any questionable bearings.
21.To disassemble the shift shaft rail remove the snap
ring 2% from the end of the shift rail on either side.

14.Remove the input shaft assembly h.
15.Remove the reverse shaft assembly j.
16.Remove the idler shaft assembly k.

CAUTION
Use caution when disassembling the shift rail. The
compressed springs on the shift rail may pop off
causing injury.

22.Remove all seals from the gearcase halves and clean
the cases in preparation for assembly.

9928689 - 2018 RZR RS1 Service Manual 6.23
© Copyright Polaris Industries Inc.