Page 311 - Manual Oficina Polaris RS1 2018 e 2019

FINAL DRIVE

FRONT BEARING CARRIER INSTALLATION CAUTION

1. Install drive shaft axle through the backside of the New bolts have a pre-applied locking agent which is
bearing carrier. destroyed upon removal. Always use new brake caliper
2. Install the upper and lower ball joint ends into the mounting bolts upon assembly.
front bearing carrier.
3. Install new pinch bolts q and nuts. Torque to 7. Install the steering tie rod end r onto the front
specification. bearing carrier.
NOTE
Refer to the photo below to ensure proper placement of
the tie rod end.

TORQUE
Ball Joint Pinch Bolts:
40 ft-lbs (54 Nm)

4. Apply Anti-Seize to drive shaft axle splines. 8. Torque the tie rod end fastener t to specification and
5. Install front wheel hub assembly w, cone washer e, install a new cotter pin t. 7
and hand tighten the castle nut. Install washer with
domed side out. TORQUE
Tie Rod End Fastener:
30 ft-lb (41 Nm) + 90°

9. Torque wheel hub nut y to specification and install a
new cotter pin u. Tighten nut slightly if necessary to
align cotter pin holes. Bend both ends of cotter pin
around end of spindle in different directions.

6. Install new brake caliper mounting bolts and torque to
specification.
TORQUE
Front Caliper Mounting Bolts:
30 ft-lb (41 Nm)
TORQUE
Wheel Hub Castle Nut:
180 ft-lbs (244 Nm)

9928689 - 2018 RZR RS1 Service Manual 7.5
© Copyright Polaris Industries Inc.