Page 314 - Manual Oficina Polaris RS1 2018 e 2019

FINAL DRIVE

7. Apply Loctite ® 603 ™ retaining compound to the REAR BEARING CARRIER INSTALLATION
outer circumference of the new bearing race w and
carefully press the new bearing into the bearing 1. Install drive shaft through the backside of the bearing
carrier housing e. carrier.

2. Install the four fasteners q that attach the rear
NOTE bearing carrier to the trailing arm. Install the one
fastener w that attaches the upper radius rod to the
®
Use care to not allow any of the Loctite compound to bearing carrier. Torque bolts to specification.
get in the bearing.
NOTE
8. Wipe the housing clean of any excess compound Use new nuts upon installation of the rear bearing
and install the snap ring r.
carrier.

TORQUE
Bearing Carrier to Trailing Arm Bolts:
42 ft-lb (54 Nm)

Radius Rod to Bearing Carrier Fasteners:
M10: 40 ft-lb (54 Nm)

3. Apply anti-seize to drive shaft splines.

7.8 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.