Page 377 - Manual Oficina Polaris RS1 2018 e 2019

STEERING / SUSPENSION

REAR STABILIZER BAR REMOVAL STABILIZER BAR INSTALLATION

1. Lift and support vehicle by the main frame. 1. Carefully install stabilizer bar through the LH wheel
2. Remove rear wheel nuts and wheels. well area.
3. Identify / mark top side of stabilizer bar to reference NOTE
during installation.
4. Remove the fasteners q retaining the stabilizer bar Be sure fuel lines and shift cable are routed ABOVE the
to the linkage on each side of the vehicle. stabilizer bar.
5. Remove the four fasteners w retaining the stabilizer
bar to the vehicle frame. 2. Fully install stabilizer bar, bushings, bracket and
bracket fasteners and stabilizer links. Center
stabilizer bar in the frame. Torque fasteners to
specification (see below).
3. Torque all fasteners to specification (see below).

4. Lubricate stabilizer bar pivot bushings via grease
fitting (fittings are accessible through skid plate).
5. Install rear wheels and wheel nuts. Torque wheel
nuts to specification.
TORQUE
Rear Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)
Stabilizer Bar Mounting Bracket Bolts:
6. Remove the bushing brackets and bushings for ease 20 ft-lb (27 Nm)
of removal. Wheel Lug Nuts:
7. Carefully remove the stabilizer from the LH wheel well 120 ft-lbs (163 Nm)
area of the vehicle.
8. Inspect the stabilizer bar for straightness. Inspect the
pivot bushings and replace if needed.

8

9928689 - 2018 RZR RS1 Service Manual 8.29
© Copyright Polaris Industries Inc.