Page 373 - Manual Oficina Polaris RS1 2018 e 2019

STEERING / SUSPENSION

4. Remove the lower radius rod mounting bolt r, nut 8. Remove the bearing carrier from the rear drive shaft
and washer from the bearing carrier. Swing radius rod and trailing arm.
down. Discard the nut.

9. Rotate bearing by hand and check for smooth
5. Remove the two brake caliper mounting bolts t. rotation. Visually inspect bearing for moisture, dirt, or
corrosion. Replace bearing if moisture, dirt, corrosion,
or roughness is evident (see “Rear Bearing
Replacement” in the Final Drive chapter).
10.Remove the four fasteners u that secure the brake
line retainers to the trailing arm.

8
CAUTION
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.

6. Remove the rear wheel hub and brake disk assembly. 11. Remove the lower stabilizer bar linkage fastener.
7. Remove the five remaining bolts y that attach the Discard the nut.
rear bearing carrier to trailing arm. Discard the nuts. 12.Support trailing arm with suitable jack stand or
support.
13.Remove the lower shock bolt. Discard the nut.

9928689 - 2018 RZR RS1 Service Manual 8.25
© Copyright Polaris Industries Inc.