Page 374 - Manual Oficina Polaris RS1 2018 e 2019

STEERING / SUSPENSION

14.Remove the front trailing arm bolt i. Discard the nut.
WARNING
Upon rear trailing arm installation, test vehicle at low
speeds before putting into service.

15.Remove trailing arm from vehicle. Visually inspect
trailing arm, bushings, o-rings and spherical bearing
for wear. If bearing requires replacement, refer to
“Trailing Arm Spherical Bearing Replacement”.
16.Replace trailing arm if physically damaged.
17.Reverse this procedure to reinstall rear trailing arm.
NOTE
Use new fastener nuts upon installation of the rear
trailing arm and bearing carrier.

18.Torque all fasteners to specification.
TORQUE
Trailing Arm to Main Frame:
(Trailing arm spherical bearing bolt)
70 ft-lb (95 Nm)

Rear Shock Mounting Bolts:
70 ft-lbs (95 Nm)
Rear Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)

Inner Radius Rod Mounting Bolts:
50 ft-lb (68 Nm) + 45°
Outer Radius Rod Mounting Bolts:
50 ft-lbs (68 Nm) + 90°

Bearing Carrier to Trailing Arm Bolts:
40 ft-lb (54 Nm)

Rear Brake Caliper Mounting Bolts:
40 ft-lbs (54 Nm)

Rear Wheel Hub Castle Nut:
180 ft-lbs (244 Nm)

Wheel Nuts:
120 ft-lbs (163 Nm)

8.26 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.