Page 391 - Manual Oficina Polaris RS1 2018 e 2019

STEERING / SUSPENSION

26.Set the IFP depth to the specified length from the top 33.Pressurize the shock reservoir through the Schrader ®
of the reservoir. valve using the Gas Shock Recharging Kit (PN
2200421).

34.Continue filling until the shaft has fully extended and
the reservoir pressure is at 150 psi.
Nitrogen Pressure (Front and Rear):
150 psi (1034 kPa) +/- 5%
MEASUREMENT
IFP Depth:
FRONT: 3.375″ (85.7 mm) WARNING
REAR: 6.25″ (158.8 mm) CHARGE THE SHOCK USING NITROGEN GAS
ONLY. DO NOT FILL WITH ANY OTHER GASES.
27.Using a long 3/32” Allen wrench, install the IFP bleed Doing so compromises the performance of the shock
screw. and may be EXTREMELY DANGEROUS!

NOTE
35.Reinstall the valve cap. 8
Apply grease to the end of the Allen wrench so the 36.Clean all oil residue from the shock and reservoir with
bleed screw sticks to it during installation. solvent, and dry with low pressure compressed air in
a well ventilated area.
28.Pour the residual shock oil out of the reservoir into a 37.Check shock for any leaks.
proper disposal container.
29.Install the reservoir cap. Push down on the reservoir NOTE
cap using even pressure until the retaining ring If leakage from a remote shock reservoir hose fitting is
groove is exposed. evident, check for a loose fitting and seal threads with
30.Install the retaining ring and check to make sure Three Bond 1215 (PN 2871557)
retaining ring is seated properly.
31.Push the shock rod assembly completely into the 38.Reinstall the compression spring and the spring
shock body. It should go all the way down smoothly retainer.
without interference. If it does not, disassemble and 39.Thread the spring preload adjuster down against the
reassemble per this procedure. spring and set the preload to the specified
32.Secure the shock body in a vise by its lower mount.
measurement (see Chapter 2 – Spring Adjustment).
40.Set the compression adjuster knob to the
recommended setting or the original setting upon
removal (see Chapter 2 – Shock Compression
Adjustment).
41.Remove the shock from the vise.

9928689 - 2018 RZR RS1 Service Manual 8.43
© Copyright Polaris Industries Inc.