Page 387 - Manual Oficina Polaris RS1 2018 e 2019

STEERING / SUSPENSION

14. Using an 11/16" socket, remove the nut retaining the 19. Front Shocks Only: Using a 9/16" socket w/
valve stack and piston. extension, remove the fastener retaining the clicker
valve stack. Place the valve stack on a clean shop
towel in order of removal.

NOTE
Keep the rebound and compression valve stacks in the NOTE
order they were removed. If unsure of order, refer to
“Shock Valving” under the “Shock Service Information” Keep the valve stack in the order it was removed. If
provided earlier in this section. unsure of order, refer to “Shock Valving” under the
“Shock Service Information” provided earlier in this
section.

20. Inspect the valves for kinks, waves, pits or foreign
material
21. Thoroughly clean all shock components and shock
body prior to assembly.

8

15. Place the valve stack on a clean shop towel in order
of removal.
16. Inspect the valves for kinks, waves, pits or foreign
material.
17. Inspect the piston wear band and replace if damaged
or worn.

18. Use the appropriate shock body holding tool to
properly secure the shock assembly into a vice for
service.
Front Shock Body Holding Tool: PU-50979
Rear Shock Body Holding Tool: PU-50938

9928689 - 2018 RZR RS1 Service Manual 8.39
© Copyright Polaris Industries Inc.