Page 405 - Manual Oficina Polaris RS1 2018 e 2019

BRAKE SYSTEM

6. Hold brake pedal down to maintain pedal pressure,
and open bleeder screw e. Close bleeder screw and
release pedal.

NOTE

Do not release foot pedal before bleeder screw is tight
or air may be drawn into master cylinder.

7. Repeat procedure until clean fluid appears in bleeder
hose and all air has been purged. Add fluid as
necessary to maintain level in reservoir.
IMPORTANT
Maintain at least 1/2"(1.27 cm) of brake fluid in the
reservoir to prevent air from entering the master
cylinder.

8. Tighten bleeder screw securely and remove bleeder
hose. Torque bleeder screw to specification.

TORQUE
Bleeder Screw:
48 in-lb (5 Nm) 9

9. Repeat steps 5 - 8 for the remaining calipers.
10.Add brake fluid to MAX level inside reservoir.
Master Cylinder Fluid Level
Between MIN and MAX lines on reservoir.

11. Install master cylinder reservoir cover.
12.Field test machine at low speed before putting into
service. Check for proper braking action and pedal
reserve. With pedal firmly applied, pedal reserve
should be no less than 1/2"(1.3 cm).
13.Check brake system for fluid leaks.

9928689 - 2018 RZR RS1 Service Manual 9.13
© Copyright Polaris Industries Inc.