Page 425 - Manual Oficina Polaris RS1 2018 e 2019
P. 425

BRAKE SYSTEM

                   DISC REPLACEMENT

                   1. Remove rear brake caliper (see Rear Caliper
                      Removal, page   ).
                   2. Remove wheel hub cotter pin r, castle nut e and
                      washer w.
                   3. Remove the hub assembly from the vehicle.






















                   4. Install new bolts t.





















                   5. Clean the wheel hub mating surface and install new                                                      9
                      disc on wheel hub.
                   6. Install wheel hub assembly, washer, and castle nut.
                      Torque castle nut to specification and install a new
                      cotter pin.
                                        TORQUE
                                     Hub Castle Nut:
                                    180 ft-lbs (244 Nm)

                   7. Install  rear  brake  caliper  (see  Rear  Caliper
                      Installation, page 9.31).
                   8. Bleed the brake system (see Brake Bleeding / Fluid
                      Change, page 9.12).
                   9. Field test unit for proper braking action before putting
                      into service. Inspect for fluid leaks and firm brakes.
                      Make sure brakes do not drag when pedal is
                      released. If the brakes drag, re-check assembly and
                      installation.




                   9928689 - 2018 RZR RS1 Service Manual                                                              9.33
                   © Copyright Polaris Industries Inc.
   420   421   422   423   424   425   426   427   428   429   430