Page 421 - Manual Oficina Polaris RS1 2018 e 2019

BRAKE SYSTEM

CALIPER REMOVAL 6. Remove the two caliper mounting bolts e and
remove the caliper.
1. Elevate and safely support the rear of the vehicle.
CAUTION
Use care when supporting vehicle so that it does not tip
or fall. Severe injury may occur.

2. Remove the four wheel nuts and rear wheel. Clean
caliper area before removal.
3. Place a container below the caliper to catch the brake
fluid when removing the line q. Remove brake line
from caliper.

4. Remove the lower radius rod outer mounting bolt w,
nut and washer from the bearing carrier. Swing radius
rod down. Discard nut.

9

5. Loosen the brake pad adjustment set screw to allow
brake pad removal after the caliper is removed.

9928689 - 2018 RZR RS1 Service Manual 9.29
© Copyright Polaris Industries Inc.