Page 423 - Manual Oficina Polaris RS1 2018 e 2019

BRAKE SYSTEM

CALIPER ASSEMBLY CALIPER INSTALLATION
1. Install new caliper seals q in the caliper body w. Be 1. Install the rear caliper with new mounting bolts.
sure groove is clean and free of residue or brakes Torque mounting bolts q to specification.
may drag upon assembly.

2. Coat piston with clean Polaris DOT 4 Brake Fluid TORQUE
(PN 2872189). Install piston e with a twisting motion
while pushing inward. Piston should slide in and out Rear Caliper Mount Bolts:
of bore smoothly with light resistance. 46 ft-lbs (62 Nm)
3. Lubricate the mounting bracket pins r with silicone 2. Install brake line banjo bolt w and torque to
grease and install the rubber dust seal boots t.
specification.

9

4. Compress the mounting bracket and make sure the
dust seals are fully seated. Install the brake pads. TORQUE
Clean the disc and pads with brake parts cleaner or
denatured alcohol to remove any dirt, oil or grease. Banjo Bolts:
15 ft-lbs (20 Nm)

9928689 - 2018 RZR RS1 Service Manual 9.31
© Copyright Polaris Industries Inc.