Page 52 - Manual Oficina Polaris RS1 2018 e 2019

MAINTENANCE

ENGINE OIL AND FILTER CHANGE 7. Using a clean dry cloth, clean the filter sealing
Always change engine oil and filter at the intervals surface on the engine crankcase.
outlined in the Periodic Maintenance Chart. Always 8. Lubricate the O-ring on the new oil filter with a film of
change the oil filter whenever changing the engine oil. fresh engine oil. Check to make sure the O-ring is in
good condition. Install it by hand until the O-ring
The engine oil dipstick is located on the front side of the contacts the sealing surface, then turn an additional
engine. Access the dipstick through the wheel well, 1/2 turn.
behind the rear right-hand fender.
TORQUE
The crankcase drain plug is located on the bottom of the
crankcase. Access the drain plug through the skid plate Oil Filter Torque:
access hole located directly under the crankcase. Turn by hand until filter O-ring contacts sealing surface,
then turn an additional 1/2 turn
1. Position vehicle on a level surface and place the
transmission in PARK. 9. Replace the sealing washer on drain plug.
2. Stop the engine and allow it to cool down.
3. Clean the area around the crankcase drain plug. NOTE
The sealing surface on the drain plug should be clean
CAUTION
and free of burrs, nicks or scratches.
Do not allow hot engine oil to come into contact with
skin, as serious burns may result. 10.Reinstall the engine crankcase drain plug. Torque
drain plug to specification.
4. Place a drain pan under the engine crankcase and
remove the drain plug q. Allow the oil to drain TORQUE
completely. Engine Oil Drain Plug:
12 ft-lbs (16 Nm)

11. Remove oil dipstick (See Chapter 2 – Engine Oil
Level). Using the oil fill funnel, fill engine with 3.0
quarts (2.9 L) of recommended engine oil.
FLUID CAPACITY
Recommended Engine Oil:
Capacity:
3.0 qt (2.9 L)
PS-4 Full Synthetic 5W-50
Ambient Temp Range: -35° F to 100° F

PS-4 Extreme Duty
5. Remove the seat and airbox access panel to access Ambient Temp Range: 0° F to 120° F
the oil filter.
6. Using the Oil Filter Wrench (PU-50105), turn the oil 12.Verify the transmission is still in PARK.
filter w counter-clockwise to remove it. 13.Start the engine and allow it to idle for 30 seconds.
14.Stop the engine and inspect for oil leaks. Wait at least
15 seconds before removing the dipstick.
15.Unlock the dipstick lever. Remove the dipstick and
wipe it dry with a clean cloth (see Chapter 2 – Engine
Oil Level).
16.Reinstall the dipstick and push it into place. Do not
lock the dipstick.

NOTE
Make certain the dipstick is inserted all the way into the
dipstick tube to keep the depth of the dipstick
consistent.

17.Remove the dipstick and check the oil level.

2.30 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.