Page 183 - Manual Oficina Polaris RZR 570 13-18

ENGINE / COOLING SYSTEM

STATOR / STATOR COVER INSTALLATION
1. Clean and degrease stator screws and threads in the
stator housing.
2. Clean mounting surfaces of stator q and housing w.
3. Apply crankcase sealant to edges of rubber stator
grommet.
4. Set the stator in housing and press wire grommet
into slot on housing.
5. Apply Loctite® 242™ to end (8-10 threads) of the 3
stator screws e and the wire routing bracket screws
r.
6. Install a new stator cover gasket.
7. Install the stator cover.
CAUTION

The flywheel contains powerful magnets. Use caution
when installing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the installation process or injury could
result.

8. Install the stator cover screws and torque to
specification.

TORQUE

Stator Mounting Bolts:
9 ft-lbs (12 Nm)Apply Loctite® 242™

TORQUE
Stator Wire Retainer:
6 ft-lbs (9 Nm)
Apply Loctite® 242™

9926813 R06 - 2013-2016 RZR 570 Service Manual 3.85
© Copyright Polaris Industries Inc.