Page 181 - Manual Oficina Polaris RZR 570 13-18

ENGINE / COOLING SYSTEM

STARTER ONE-WAY CLUTCH FLYWHEEL INSTALLATION
INSTALLATION 1. Clean the threads q, taper w and flat e of
1. Install one-way clutch in clutch hub with flange of crankshaft to remove all oil or grease.
clutch q facing the flywheel.

3

2. Clean flywheel taper r to remove all oil or grease.

NOTE
The one-way clutch can be installed into the hub
incorrectly. This will cause engine cranking issues.

2. Clean screw threads in flywheel to remove all oil or
grease.
3. Apply Loctite® 272™ on the one way clutch retaining
bolts threads w. Place hub on flywheel and install
bolts.
4. Torque screws to specification.

3. Apply a small amount of PS4 engine oil to the flat
area t on the MAG side crankshaft. DO NOT apply
engine oil to the crankshaft taper.

TORQUE

One Way Clutch Retaining Bolts:
9 ft-lbs (12 Nm) Apply Loctite® 272™

4. Rotate crankshaft so the flywheel key y is facing
upward.

9926813 R06 - 2013-2016 RZR 570 Service Manual 3.83
© Copyright Polaris Industries Inc.