Page 274 - Manual Oficina Polaris RZR 570 13-18

TRANSMISSION

SHIFT LEVER / CABLE

SHIFT LEVER REMOVAL 4. Remove the retaining ring e and washer. Slide the
shift lever off the mounting bracket and out from the
1. Remove the shift knob cover, retaining screw and
shift knob from the shift lever. frame.
5. Remove both bushings from the shift lever and
service as needed.

SHIFT LEVER INSTALLATION
1. Perform the removal steps in reverse order to install
the gear shift lever (lever, cable, console, shift knob).
Torque all fasteners to specification.

TORQUE
Shift Cable Fastener:
13 ft-lb (18 Nm)

Center Console Fasteners:
8 ft-lb (11 Nm)
2. Remove the fasteners q retaining the center
console. Remove the console from the vehicle. Shifter Knob Fastener:
8 ft-lb (11 Nm)

SHIFT CABLE INSPECTION
Shift cable adjustment may be necessary if symptoms
include:
• No gear position or AWD display on instrument cluster
• Ratcheting noise on deceleration
• Inability to engage into a gear
• Excessive gear clash (noise)
• Gear selector moving out of desired range
Inspect shift cable, clevis pins, and pivot bushings and
replace if worn or damaged.
3. Remove the fastener w retaining the shift cable to SHIFT CABLE ADJUSTMENT
the shift lever and remove the cable end from the
lever. 1. Locate the shift cable attached to the transmission
case in the right rear wheel well area.

6.4 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.