Page 405 - Manual Oficina Polaris RZR 570 13-18

BRAKE SYSTEM

FRONT BRAKE PADS 5. Push caliper piston into caliper bore slowly using a
C-clamp or locking pliers with pads installed.
PAD REMOVAL

1. Elevate and support front of vehicle.
CAUTION
Use care when supporting vehicle so that it does not tip
or fall. Severe injury may occur if machine tips or falls.

2. Remove the front wheel.
3. Loosen the pad adjuster screw 2-3 turns.

NOTE
Brake fluid will be forced through compensating port
into master cylinder fluid reservoir when piston is
pushed back into caliper. Remove excess fluid from
reservoir as required.

6. Push the mounting bracket inward and the slip outer
4. Remove and discard the upper and lower caliper brake pad out between the bracket and caliper body.
mounting bolts and remove the caliper from the front
hub.
NOTE
When removing caliper, use care not to damage brake
line. Support caliper so to avoid kinking or bending
brake line.

9

7. Remove the inner pad from the bracket and caliper.

9926813 R06 - 2013-2016 RZR 570 Service Manual 9.19
© Copyright Polaris Industries Inc.