Page 407 - Manual Oficina Polaris RZR 570 13-18

BRAKE SYSTEM

5. Install the adjustment set screw and turn clockwise BRAKE BURNISHING PROCEDURE
until stationary pad contacts disc, then back off 1/2 It is required that a burnishing procedure be performed
turn (counterclockwise). after installation of new brake pads to extend service life
and reduce noise.
Start machine and slowly increase speed to 30 mph.
Gradually apply brakes to stop machine. Allow pads and
disc to cool sufficiently during the procedure. Do not
allow pads or disc to become hot or warping may result.
Repeat this procedure 10 times. Do not make more
than 3 stops per 1 mile (1.6 km).

6. Verify fluid level in reservoir is up to MAX line inside
reservoir and install reservoir cap.
Master Cylinder Fluid:
Up to MAX line inside reservoir

7. Install wheel and torque wheel nuts to specification.
TORQUE
Wheel Nuts:
RZR 570 Steel Rims: 36 ft-lbs (49 Nm)
RZR 570 EPS Alum. Rims: 120 ft-lb (163 Nm)
RZR S 570 Alum. Rims: 30 ft-lbs (41 Nm) + 90°

9

9926813 R06 - 2013-2016 RZR 570 Service Manual 9.21
© Copyright Polaris Industries Inc.