Page 411 - Manual Oficina Polaris RZR 570 13-18
P. 411

BRAKE SYSTEM

                   CALIPER ASSEMBLY                                      CALIPER INSTALLATION
                   1. Install new O-rings in the caliper body. Be sure the  1. Install the brake line onto the caliper taking care not
                       grooves are clean and free of residue or brakes may   to allow any debris to enter the caliper.
                       drag upon assembly.
                                                                         2. Install the caliper and torque the new mounting bolts
                                                                             to specification.

                                                                                             TORQUE
                                                                                       Front Caliper Mount Bolt:
                                                                                          30 ft-lbs (41 Nm)
                                                                         3. Torque the banjo bolt to the proper torque
                                                                             specification.











                   2. Coat pistons with clean Polaris DOT 4 Brake Fluid.
                       Install pistons with a twisting motion while pushing
                       inward. Piston should slide in and out of bore
                       smoothly, with light resistance.
                   3. Lubricate the mounting bracket pins with silicone
                       grease and install the rubber dust seal boots.


                                                                         4. Install the adjustment set screw and turn clockwise
                                                                             until stationary pad contacts disc, then back off 1/2
                                                                             turn (counterclockwise).







                                                                                                                              9








                   4. Compress the mounting bracket and make sure the
                       dust seal boots are fully seated. Install the brake
                       pads. Clean the disc and pads with brake parts
                       cleaner or denatured alcohol to remove any dirt, oil
                       or grease.
                                                                         5. Perform brake bleeding procedure as outlined earlier
                                                                             in this chapter.













                   9926813 R06 - 2013-2016 RZR 570 Service Manual                                                     9.25
                   © Copyright Polaris Industries Inc.
   406   407   408   409   410   411   412   413   414   415   416