Page 455 - Manual Oficina Polaris RZR 570 13-18
P. 455
ELECTRICAL
neutral. If throttle is applied, this limiting feature 3. A set of three numbers will appear in the information
prevents operation, which protects the park brake area.
pads from excessive wear. • The first number (located far left) can range from 0 to
9. This number represents the total number of trouble
code present (example: 2 means there are 3 codes
present).
• The second number (located top right) can be 2 to 6
digits in length. This number equates to the suspected
area of fault (SPN).
• The third number (located bottom right) can be 1 to 2
digits in length. This number equates to the fault mode
(FMI).
DIAGNOSTIC MODE
The diagnostic mode is accessible only when the check
engine MIL has been activated.
Use the following procedure to display diagnostic trouble
codes that were activated during current ignition cycle
causing the MIL to illuminate. Diagnostic trouble codes
will remain stored in the gauge (even if MIL turns off) until
the key is turned off.
1. If the trouble code (s) are not displayed, use the
MODE button to toggle until “CK ENG” displays on
the information display area.
4. Use the trouble code reference table in the EFI
Chapter for a description of each code.
5. If more than one code exists, press the MODE button
to advance to the next trouble code.
6. To exit the diagnostic mode, press and hold the
MODE button or turn the ignition key OFF once the
codes are recorded.
NOTE
If there is a diagnostic problem with the power steering
system, the power steering MIL will illuminate and blink
in place of the check engine MIL.
2. Press and hold the MODE button to enter the
diagnostics code menu.
11
9926813 R06 - 2013-2016 RZR 570 Service Manual 11.9
© Copyright Polaris Industries Inc.