Page 90 - Manual Oficina Polaris RZR 570 13-18

MAINTENANCE

WHEEL TOE ALIGNMENT INSPECTION WHEEL TOE ADJUSTMENT
1. Place machine on a smooth level surface and set If toe alignment is incorrect, measure the distance
steering wheel in a straight ahead position. Secure between vehicle center and each wheel. This will tell you
the steering wheel in this position. which tie rod needs adjusting.
2. Place a chalk mark on the center line of the front tires
approximately 10” (25.4 cm) from the floor or as
close to the hub/axle center line as possible.

NOTE
It is important the height of both marks be equally
positioned to get an accurate measurement.

3. Measure the distance between the marks and record
the measurement. Call this measurement “A”.
NOTE
4. Rotate the tires 180° by moving the vehicle forward.
Position chalk marks facing rearward, even with the Be sure steering wheel is straight ahead before
hub/axle center line. determining which tie rod needs adjustment.
5. Again measure the distance between the marks and
record. Call this measurement “B”. Subtract CAUTION
measurement “B” from measurement “A”. The
difference between measurements “A” and “B” is the During tie rod adjustment, it is very important that the
vehicle toe alignment. The recommended vehicle toe following precautions be taken when tightening tie rod
tolerance is 1/8 to 1/4″ (3 to 6 mm) toe out. This end jam nuts.
means the measurement at the front of the tire (A) is If the rod end is positioned incorrectly it will not pivot,
1/8 to 1/4″ (3 to 6 mm) wider than the measurement and may break.
at the rear (B).
To adjust toe alignment:
MEASUREMENT
• Hold tie rod end to keep it from rotating.
Wheel Toe-Out: • Loosen jam nuts at both end of the tie rod.
(A) - (B) = 1/8 - 1/4" (3 to 6 mm) • Shorten or lengthen the tie rod until alignment is as
required to achieve the proper toe setting as specified
in “Wheel Toe Alignment”.

2.50 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.