Page 87 - Manual Oficina Polaris RZR 570 13-18
P. 87

MAINTENANCE

                   SHIFT CABLE INSPECTION / ADJUSTMENT                   FRONT GEARCASE LUBRICATION
                   Shift cable adjustment may be necessary if symptoms
                   include:                                                                    NOTE
                   • No AWD or gear position display on instrument cluster  It is important to follow the front gearcase maintenance
                   • Ratcheting noise on deceleration                     intervals described in the Periodic Maintenance Chart.
                   • Inability to engage into a gear                      Regular fluid level inspections should be performed as  2
                   • Excessive gear clash (noise)                                               well.
                   • Gear selector moving out of desired range
                                                                         The front gearcase fluid level should be checked and
                   1. Locate the shift cable q in the rear right wheel well  changed in accordance with the maintenance schedule.
                       area.
                                                                         • Be sure vehicle is positioned on a level surface when
                                                                           checking or changing the fluid.
                                                                         • Check vent hose to be sure it is routed properly and
                                                                           unobstructed.
                                                                         Front Gearcase Fluid Level Check
                                                                         The fill plug is located on the right side of the front
                                                                         gearcase. Access the fill plug through the right front
                                                                         wheel well. Maintain fluid level even with the bottom of
                                                                         the fill plug hole.
                                                                         1. Position vehicle on a level surface.
                                                                         2. Remove the fill plug q and check the fluid level.




                   2. Inspect shift cable, clevis pin w, pivot bushings, and
                       dust boot e. Replace if worn or damaged.
                   3. If adjustment is required: Loosen outer jam nut r
                       and inner jam nut t so there is slack in the cable
                       and neither jam nut touches the shift cable mount.
                   4. Adjust the shift cable so there is the same amount of
                       cable travel when shifting slightly past the detents of
                       HIGH (H) gear and PARK (P).
                   5. Thread jam nut as required to obtain proper cable
                       adjustment.

                                         NOTE
                                                                         3. If fluid level is not even with the bottom threads, add
                      This procedure may require a few attempts to obtain    the recommended fluid as needed. Do not overfill.
                                  the proper adjustment.
                                                                         4. Reinstall the fill plug and torque to specification.
                   6. Once the proper adjustment is obtained, place the                      TORQUE
                       shift cable and inner jam nut into the mount. Tighten
                       the outer jam nut against the mount.                                Fill / Drain Plug:
                                                                                          10 ft-lbs (14 Nm)
                   7. Start engine and shift through all gears to ensure the
                       shift cable is properly adjusted. If transmission still
                       ratchets after cable adjustment, the transmission will
                       require service.                                      Front Gearcase Fluid Change:
                                                                             The drain plug is located on the bottom of the front
                                                                             gearcase. Access the drain plug through the access
                                                                             hole in the frame underneath the front gearcase.
                                                                         5. Remove the fill plug q.

                                                                         6. Place a drain pan under the front gearcase drain
                                                                             plug.




                   9926813 R06 - 2013-2016 RZR 570 Service Manual                                                     2.47
                   © Copyright Polaris Industries Inc.
   82   83   84   85   86   87   88   89   90   91   92