Page 129 - Manual_Polaris_RZR_ProXP-20-21

MAINTENANCE

PVT / FINAL DRIVE / WHEEL AND TIRE
PVT DRAIN PVT INTAKE PRE-FILTER SERVICE
If water is ingested into the PVTsystem: It is recommended that the PVT intake pre-filter be
inspected daily. The filter should be inspected using the
1. Remove the clutch cover drain plug q.
following procedure:
2
1. The PVT intake pre-filter is located just above the left
rear wheel fender.
2. Inspect the pre-filter on the outboard q and inboard
w sides. If necessary, clean with soapy water and air
dry.

2. Allow the water to drain out. Reinstall the plug.

3. Place the transmission in Park. Apply the brakes.
4. Start the engine and apply varying throttle for 10-15
seconds to expel any moisture from the PVTand air
dry the belt and clutches.
CAUTION CAUTION
Do not hold the throttle wide open for more than 10 Compressed air or high pressure hose may damage the
seconds. pre-filter material on the intake.

5. Allow the engine RPM to settle to idle speed. Apply
the brakes. Shift the transmission into Low.
6. Test run the vehicle for slippage. If the belt slips,
repeat steps 1-5.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 2.43
© Copyright Polaris Industries Inc.