Page 209 - Manual_Polaris_RZR_ProXP-20-21

ENGINE / COOLING SYSTEM

5. Fully install Flywheel Puller PA-49316 e on the STARTER ONE-WAY CLUTCH
threads of the flywheel (left hand thread - turn DISASSEMBLY
flywheel puller counterclockwise to install).
1. Lift up to remove starter one-way gear q.

3

6. Hold puller body and tighten the center bolt w to
remove the flywheel. 2. Remove the three one-way clutch retaining screws
w.
Starter One-Way Clutch Inspection
3. Remove the one-way clutch and inspect both sides of
NOTICE drive rollers e. Inspect the roller contact surface r
The starter one-way clutch can be serviced with the inside the hub for wear, damage or uneven surface.
engine installed in the chassis.

7. Place flywheel on a work bench with the one-way
clutch facing up. Grasp clutch gear and rotate
clockwise. It should turn smoothly without binding.
8. Rotate one-way gear counterclockwise. The gear
should immediately lock in position and not slip.
9. Inspect the one-way gear bushing r for wear or
galling. If service is required, refer to Starter One-way
Clutch Disassembly page 3.65.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 3.65
© Copyright Polaris Industries Inc.