Page 315 - Manual_Polaris_RZR_ProXP-20-21

PVT SYSTEM

BUTTON TO TOWER CLEARANCE ROLLER, PIN, AND THRUST WASHER
INSPECTION INSPECTION
1. Inspect for any clearance between spider button to 1. Inspect all rollers e, roller pins r, roller washers w,
tower. If clearance exceeds specification, replace all and roller caps q by pulling a flat metal rod across
buttons and inspect surface of towers. Refer to the roller.
Spider Removal page 6.12 procedure.
2. Turn roller with your finger. If you notice resistance,
galling, or flat spots, replace all the rollers.

Button to Tower Clearance:
0.000 - 0.020”
6

2. Inspect sheave surfaces. Replace the entire clutch if
worn, damaged or cracked.

SPIDER REMOVAL

1. Remove the spider assembly. If the spider cannot be
removed by hand, use a conventional 3-jaw puller as
shown to remove the spider from the clutch assembly.

IMPORTANT
Do not pull on the outer fingers of the spider or damage
may occur. Position 3 jaw puller in the positions shown
u.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 6.25
© Copyright Polaris Industries Inc.