Page 320 - Manual_Polaris_RZR_ProXP-20-21

PVT SYSTEM

5. Turn clutch cover counterclockwise on puller rod until 2. Install clutch spider as shown r.
bushing is seated.
NOTICE
6. Remove nut from puller rod. Take installation tool and
clutch cover off rod. If necessary, once the splines are aligned properly, an
arbor press may be used to properly seat the clutch
spider.
CLUTCH ASSEMBLY
NOTICE
The Teflon® bushings are self-lubricating.

CAUTION
Do not apply oil or grease to the bushings.

Reassemble the drive clutch in the following sequence.
Be sure the “X”, or the marks that were made earlier are
aligned during each phase of assembly.

3. Install washer t, belleville washer y, and clutch
spring u.

IMPORTANT
Belleville washer must be installed with dome facing the
outer post.

1. Install two washers q, needle bearing w, and clutch
spacer e onto the stationary sheave in the order
shown.

6.30 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.