Page 376 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

10.Install and tighten the large clamp e using the INNER PLUNGING JOINT / BOOT
appropriate clamp tool. REPLACEMENT

NOTICE
This procedure applies to the front drive axles only.

1. Use a side cutters to cut and discard the boot clamps
q.

Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226

11. While pulling out on the CV shaft, fully extend the CV
joint and slide a straight O-ring pick or a small slotted
screw driver between the small end of the boot and 2. Remove the large end of the boot from the plunging
the shaft. This will allow the air pressure to equalize in joint and slide the boot down the shaft.
the CV boot in the position that the joint will spend
most of its life. Before you remove your instrument,
be sure the small end of the boot is in its correct
location on the shaft.
12.Install and tighten the small clamp r on the boot
using the appropriate clamp tool.

3. Clean the grease from the face of the joint.

8.18 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.