Page 372 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

6. Using a commercially available two-jaw puller rated to REAR DRIVE SHAFT INSTALLATION
a minimum of 3 tons, press the drive shaft out of the
hub/bearing carrier assembly. 1. Install new spring ring q on drive shaft. Apply an
anti-seize compound to the splines w.

NOTICE
IMPORTANT
Hub not shown for image clarity.
Apply anti-seize to the transmission-side splines only.
Do not apply anti-seize to the hub-side splines.

CAUTION
2. Align splines of drive shaft with transmission splines
Do NOT use a puller on the brake rotor to remove the
drive shaft. and reinstall the drive shaft. Use a rubber mallet to
tap on the outboard end of the drive shaft if
Do NOT use heat to remove drive shaft from hub.
necessary.
3. Clean drive shaft splines and hub assembly splines
7. With a short, sharp jerk, remove drive shaft from the thoroughly with contact cleaner and wire brush.
transmission splines. Remove all/any Loctite® residue.
IMPORTANT
Removal of all Loctite® material is a labor intensive
process and may take up to 10 minutes or more to
complete. It is critical that these surfaces are clean and
no residual Loctite® material or corrosion is present.

4. Apply Loctite® Primer 7649 to the hub assembly
splines. Allow 90 seconds for the primer to dry.

8.14 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.