Page 373 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

5. Apply Loctite® 680 to the hub-side splines of the 7. Install NEW cone washer r into the hub assembly e
drive shaft. Apply Loctite® 680 around the entire with domed side facing out, and NEW castle nut.
circumference of the end of the hub-side splines, and Torque castle nut to specification. Install NEW cotter
then apply Loctite® 680 in a spiral pattern as shown. pin t. Tighten nut slightly if necessary to align cotter
pin holes. Bend both ends of cotter pin around end of
spindle in different directions.

CAUTION
Use caution to avoid getting Loctite® on the drive shaft
threads or castle nut.

6. Insert rear drive shaft into the bearing carrier/hub
assembly.

8

TORQUE
Rear Hub Castle Nut:
180 ft-lbs (244 Nm)

8. Install the radius rod bolts, washers and new nuts.
NOTICE Torque fasteners to specification.
Hub assembly hidden for image clarity TORQUE
Radius Rods to Bearing Carrier:
52 ft-lbs (70 Nm) + 90°

9. Install wheel and four wheel nuts. Torque wheel nuts
to specification.
TORQUE
Wheel Lug Nuts:
120 ft-lbs (163 Nm)

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 8.15
© Copyright Polaris Industries Inc.