Page 390 - Manual_Polaris_RZR_ProXP-20-21
P. 390

FINAL DRIVE

                FRONT GEARCASE VENT LINE ROUTING
                The front gearcase vent line routes up the LH shock support tube. It is then retained with two hinge clips q. The vent
                line continues upward and terminates into and open section of the frame using a termination fitting w.







































                ALL WHEEL DRIVE OPERATION                            AWD Engagement: When the AWD switch is activated,
                The AWD switch may be turned on or off while the     the AWD coil is powered by a 12 VDC input which
                vehicle is moving, however, AWD will not enable until the  creates a magnetic field. This magnetic field attracts an
                engine RPM drops below 3100. Once the AWD is         armature plate q that is keyed to the roll cage w. When
                enabled, it remains enabled until the switch is turned off.  the ring gear e and roll cage are spinning (vehicle is
                                                                     moving), the energized coil and armature plate will apply
                Engage the AWD switch before getting into conditions  drag to the roll cage that indexes the rollers inside the
                where the front wheel drive may be needed. If the rear  ring gear to an engagement position. While in the
                wheels are spinning, release the throttle before switching  engagement position, the front drive will be in an “over-
                to AWD.                                              running” condition (not engaged), until the rear wheels
                                                                     lose traction. Once the rear wheels begin to lose traction,
                                      CAUTION                        the front drive will engage by coupling the output hubs r
                                                                     to the ring gear via the rollers. The front drive will remain
                  Switching to AWD while the rear wheels are spinning
                  may cause severe drive shaft and gearcase damage.  engaged until the torque requirement goes away (i.e.
                   Always switch to AWD while the rear wheels have   rear wheels regain traction).
                               traction or are at rest.              AWD Disengagement: Once the rear wheels regain
                                                                     traction, the front wheels will return to the “over-running”
                With the AWD switch off, the vehicle drives through the  condition. The vehicle is now back to rear wheel drive
                rear wheels only (2 wheel drive). When the AWD is    until the next loss of rear wheel traction occurs.
                enabled, the front drive acts as an on-demand AWD
                system. This means, the front drive will engage once the
                rear wheels have lost traction, and will remain engaged
                until the torque requirement goes away (i.e. rear wheels
                regain traction).







                8.32                                                       9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
                                                                                                © Copyright Polaris Industries Inc.
   385   386   387   388   389   390   391   392   393   394   395