Page 387 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

SUPPORT BEARING REPLACEMENT 1. Remove external snap ring q from all four bearing
caps.
1. Remove front prop shaft from the vehicle (see Prop
Shaft Removal / Installation page 8.21).
2. Using a hydraulic press, remove support bearing and
isolator bearing support as an assembly.

NOTICE
If yoke or bearing is removed, cross bearing must be
replaced. Note orientation of grease fitting (if equipped)
and mark inner and outer yoke for correct re-positioning
3. Clean the bearing mounting surface on the shaft.
during installation.
4. Install new support bearing and isolator bearing
support assembly onto the end of the prop shaft.
2. Support inner yoke as shown and drive outer yoke
5. Using a hydraulic press, install the support bearing down (bearing cap out) with a suitable press.
assembly onto the prop shaft.
IMPORTANT
The notch on the bearing support should be oriented as
shown.

8

6. Install front prop shaft into the vehicle (see Prop Shaft
Removal / Installation page 8.21).

U-JOINT DISASSEMBLY

CAUTION
Always wear eye protection.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 8.29
© Copyright Polaris Industries Inc.