Page 431 - Manual_Polaris_RZR_ProXP-20-21

STEERING / SUSPENSION

STABILIZER BAR REMOVAL / 5. Install rear wheels and wheel nuts. Torque wheel nuts
INSTALLATION to specification.
REMOVAL TORQUE
1. Lift and support vehicle by main frame. Rear Stabilizer Bar Linkage:
44 ft-lbs (60 Nm)
2. Remove rear wheel nuts and wheels.
3. Identify / mark top side of the stabilizer bar to Stabilizer Bar Mounting Bracket Bolts:
reference during installation. 30 ft-lbs (40 Nm)
Wheel Lug Nuts:
4. Remove the fasteners retaining the stabilizer bar to
the linkage q on each side of the vehicle. 120 ft-lbs (163 Nm)

5. Remove the four fasteners w retaining the stabilizer
bar to the vehicle frame.
6. Remove the bushing brackets and bushings for ease
of removal.
7. Carefully remove the stabilizer from the LH wheel well
area of the vehicle.
8. Inspect the stabilizer bar for straightness. Inspect the
pivot bushings and replace if needed.
INSTALLATION
9
1. Carefully install stabilizer bar through the LH wheel
well area.
NOTE
Be sure fuel lines and shift cable are routed ABOVE the
stabilizer bar.

2. Fully install stabilizer bar, bushings, bracket and
bracket fasteners and stabilizer links. Center
stabilizer bar in the frame. Torque fasteners to
specification (see below).
3. Torque all fasteners to specification (see below).
4. Lubricate stabilizer bar pivot bushings via grease
fitting.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 9.27
© Copyright Polaris Industries Inc.