Page 432 - Manual_Polaris_RZR_ProXP-20-21

STEERING / SUSPENSION

SHOCKS / SPRINGS
SHOCK ASSEMBLY VIEW SHOCK REMOVAL / INSTALLATION

1. Elevate the vehicle off the ground to relieve the
suspension load.
2. Support under A-arm or trailing arm.
3. If equipped, disconnect Dynamix electrical
connection and cut cable tie retaining harness to the
shock body.
4. Remove the upper and lower fasteners retaining the
shock and remove the shock from the vehicle.
5. Reverse the procedure to reinstall the shock. Torque
fasteners to specification.
IMPORTANT
q Front Shock q Rear Shock Ensure Dynamix equipped models have the harness
44 ft-lbs (60 Nm) 74 ft-lbs (100 Nm) properly secured to the shock body.
Retainer gap should be 180 degrees from spring end.
TORQUE
Front Shock Mounting Bolts ( Top and Bottom):
44 ft-lbs (60 Nm)

Rear Shock Mounting Bolts (Top and Bottom):
74 ft-lbs (100 Nm)

SHOCK / SPRING REPLACEMENT
NOTICE
Rear shock shown.

1. Remove the shock. See Shock Removal /
Installation page 9.28.
2. Remove three fasteners q securing mud guard.

3. Use spanner wrench (2878925-329) loosen the jam
nut (if applicable) and adjustment ring until the spring
is loose.

9.28 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.