Page 429 - Manual_Polaris_RZR_ProXP-20-21

STEERING / SUSPENSION

2. Torque all fasteners to specification. TRAILING ARM SPHERICAL BEARING
REPLACEMENT
TORQUE
Trailing Arm to Main Frame: 1. Remove trailing arm. See Trailing Arm Removal
74 ft-lbs (100 Nm) outlined in this chapter.
2. Remove bushings and O-rings.
Rear Shock Mounting Bolts: 3. Remove snap ring q that retains the spherical
74 ft-lbs (100 Nm)
bearing.
Rear Stabilizer Bar Linkage:
44 ft-lbs (60 Nm)
Radius Rod Mounting Bolts (inner):
52 ft-lbs (70 Nm) + 45°
Radius Rod Mounting Bolts (outer):
52 ft-lbs (70 Nm) + 90°

Brake Line Guide Fasteners:
7 ft-lbs (10 Nm)

Bearing Carrier to Trailing Arm Bolts:
44 ft-lbs (60 Nm)
Rear Brake Caliper Mounting Bolts:
33 ft-lbs (45 Nm)
4. Properly support the trailing arm and press the
Rear Wheel Hub Castle Nut: spherical bearing out of trailing arm casting.
180 ft-lbs (244 Nm) 5. Be sure to only press on outer most surface of
bearing race, do not press on the center spherical
Wheel Nuts: bearing.
120 ft-lbs (163 Nm)

3. After rear trailing arm installation, test vehicle at low
speeds before putting into service.

9

6. Inspect trailing arm bearing housing for wear or
damage. Replace trailing arm if damaged.
7. Press in new bearing until fully seated into trailing
arm casting.
8. Install new snap ring, O-rings (not required) and
bushings.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 9.25
© Copyright Polaris Industries Inc.