Page 445 - Manual_Polaris_RZR_ProXP-20-21

STEERING / SUSPENSION

4. Remove reservoir end cap from reservoir. 8. Press down on bearing assembly and remove
retaining ring.

5. Slide body cap removal tool over body and place the
retaining ring from the reservoir end cap around the 9. Remove the shaft assembly and body assembly.
body cap. Slide the tool up to the retaining ring and
tap with hammer to remove.

10.Use the IFP tool to hold the IFP.

6. Once the cap is removed it will expose the bearing IFP Tool:
assembly. On 2.5 diameter shocks, you will need to commercially available 9
apply a sufficient amount of heat to the bearing also available from FOX 398-00-780
assembly to break the Loctite bond between the cinch
ring and the bearing assembly.
11. Remove bleed screw and o-ring with extra long 1/8"
hex wrench.
NOTICE
The seal will be destroyed from the heat and must be
replaced.

7. Hold cinch ring with spanner and rotate bearing
assembly counter-clockwise to release pressure on
retaining ring.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 9.41
© Copyright Polaris Industries Inc.