Page 503 - Manual_Polaris_RZR_ProXP-20-21

BRAKE SYSTEM

FRONT BRAKE DISC REPLACEMENT BRAKE CALIPER / PAD INSTALLATION

1. Remove the hub cotter pin, castle nut and washers. 1. Install the bolt q retaining the brake line fitting to the
caliper. Torque banjo bolt to specification.
2. Remove the wheel hub assembly from the vehicle by
pulling straight out.
3. Press out the four studs retaining the disc to the hub.
4. Replace the brake disc with a new one.

5. Press in new wheel studs to retain the disc to the hub.
6. Install hub onto the vehicle. Install the two washers
and new castle nut. Torque fastener to specification.
TORQUE
Wheel Hub Castle Nut:
180 ft-lbs (244 Nm)

7. Install new cotter pin into castle nut and install wheel
cap.
NOTICE
The calipers have self-orienting features, brake lines do
not need to be oriented if installed correctly.

TORQUE
Brake Line Banjo Bolt:
15 ft-lbs (20 Nm)

2. Install the inner pad on the bracket and caliper.

3. Install the outer brake pad between the bracket and
caliper body.
4. Install the caliper on the knuckle. Torque mounting
fasteners to specification.
TORQUE
Brake Caliper Mounting Bolts:
33 ft-lbs (45 Nm)

5. Slowly pump the brake pedal until pressure has been
built up. Maintain at least 1/2" (12.7 mm) of brake 10
fluid in the reservoir to prevent air from entering the
brake system.
6. Install the adjustment set screw and turn clockwise
until stationary pad contacts disc, then back off 1/2
turn (counterclockwise).
7. Install the front wheel and the wheel nuts.
TORQUE
Wheel Lug Nuts:
120 ft-lbs (163 Nm)

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 10.25
© Copyright Polaris Industries Inc.