Page 552 - Manual_Polaris_RZR_ProXP-20-21

ELECTRICAL

TRANSMISSION / GEAR POSITION BRAKE PRESSURE SWITCH
SWITCH The brake pressure switch q is located on the rear brake
The transmission (gear position) switch q is located on line outlet on the master cylinder.
the RH side of the transmission and can be accessed
through the rear RH wheel well area.

TORQUE
Brake Pressure Switch:
TESTING 15 ft-lbs (20 Nm)
1. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the connector. Do NOTICE
not pull on the wiring.
Always replace brake system seals if fastener is
2. Test the transmission switch continuity readings for loosened or removed.
each gear position and compare to the specification
table below.
1. Disconnect the wire harness from the brake switch.
RESISTANCE VALUE
GEAR WHEN MEASURED AT SWITCH 2. Connect an ohmmeter across switch contacts.
POSITION Reading should be infinite (OL).
TERMINALS A AND B
HIGH 620 Ω 3. Apply foot brake and check for continuity between
switch contacts. If there is no continuity or greater
LOW 300 Ω than 0.5 Ω resistance when the brake is applied with
slight pressure, first clean the switch contacts and re-
NEU 160 Ω
test. Replace switch if necessary.
REV 75 Ω
PARK 24 Ω

12.16 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.