Page 550 - Manual_Polaris_RZR_ProXP-20-21

ELECTRICAL

SWITCHES / CONTROLS
HEADLAMP SWITCH IGNITION / KEY SWITCH
1. Disconnect the headlamp switch harness by
depressing the connector locks and pulling on the 1. Disconnect the key switch harness by depressing the
connector. Do not pull on the wiring. connector lock and pulling on the connector. Do not
pull on the wiring.
2. Test between the 3 sets of outputs (OFF / LOW /
HIGH). If any of the tests fail, replace headlamp 2. Test between the 4 sets of outputs (OFF / ACCY / ON
switch assembly. / START). If any of the tests fail, replace ignition
switch assembly.
• Move the switch to HIGH. There should be continuity
between switch pins 2 and 3; 5 and 6; 7 and 8. • In the OFF position, there should be no continuity
between any of the pins.
• Move the switch to LOW. There should be continuity
between switch pins 2 and 3; 4 and 5; 7 and 8.. • Turn the key to ACCY position. There should be
contunity between switch pins A and B.
• Move the switch to OFF. There should be continuity
between switch pins 1 and 2; 4 and 5; 7 and 8. • Turn the key to ON position. There should be
continuity between switch pins A, B and D.
• Turn the key to START position. There should be
continuity between all the pins on the switch.

NOTICE
Pins 7 and 8 provide power and ground to light the
switch lamp.

12.14 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.