Page 551 - Manual_Polaris_RZR_ProXP-20-21

ELECTRICAL

AWD / 2WD SWITCH (NO TURF MODE) SEAT BELT SWITCH
1. Disconnect the AWD / 2WD switch harness by Location
depressing the connector locks and pulling on the Found on the driver’s seat belt latch
connector. Do not pull on the wiring.
2. Test between the 2 sets of outputs (AWD / 2WD). If Functionality
any of the tests fail, replace the switch assembly. If the circuit is open (buckle undone) vehicle speed will
be limited to 15mph. If the circuit is closed (buckle
• Move the switch to AWD (ON). There should be inserted), the vehicle will function normally.
continuity between switch pins 2 and 3 as well as 3
and 7.
Testing:
• Move the switch to 2WD (NONE / OFF). There should
ONLY be continuity between pins 3 and 7. 1. Disconnect the harness q running to the seat belt.

2. Using a multi-meter, measure between both pins on
switch.
SEAT BELT SEAT BELT
DISENGAGED ENGAGED
Between both ∞ (OL)
pins on switch < 1 Ω

12

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 12.15
© Copyright Polaris Industries Inc.