Page 558 - Manual_Polaris_RZR_ProXP-20-21
P. 558

ELECTRICAL

                TEST 2: RESISTANCE VALUE OF EACH                     REGULATOR / RECTIFIER (DYNAMIX)
                STATOR LEG TO GROUND                                 The dual regulator / rectifier assemblies are located
                Measure the resistance value of each of the stator legs to  behind the front fascia grill in front of the radiator.
                ground: Y1 to Ground, Y2 to Ground, Y3 to Ground.    If the regulator / rectifier case temperature exceeds 230°
                Each test should measure:                            F or 110° C, the unit will turn itself off to cool down. The
                                                                     unit will turn on again after it has cooled down to at least
                                    CONNECT        OHMS
                 TEST               METER          READING           212° F or 100° C. If it turns off, verify the cooling fins are
                                    LEADS TO:                        clean, free from debris and that adequate airflow is
                                                                     present.
                 Battery Charge     Y1, Y2, or Y3  Open Line
                 Coil               to Ground      (Infinity)        REGULATOR REPLACEMENT
                                                                     1. Remove the seat and disconnect the negative battery
                                     NOTICE                             terminal.
                Any measurement other than Infinity (open) will indicate  2. Remove the front fascia grill cover by pulling down on
                            a failed or shorted stator leg.             the two tabs to release it.


                TEST 3: MEASURE AC VOLTAGE OUTPUT
                OF EACH STATOR LEG AT CHARGING RPM
                1. Set the selector dial to measure AC Voltage.
                2. Start the engine and let it idle.
                3. While holding the engine at a specified RPM,
                   separately measure the voltage across each ‘leg’ of
                   the stator by connecting the meter leads to the wires
                   leading from the alternator (Y1 to Y2, Y1 to Y3, Y2 to
                   Y3).
                4. Refer to the following table for approximate AC
                   Voltage readings according to RPM. Test each leg at
                   the specified RPM in the table.
                                                                     3. Disconnect the two wiring harnesses going to the
                                     NOTICE                             regulator(s) being removed.
                 If one or more of the stator leg output AC voltage varies  4. Remove the two fasteners w retaining the regulator
                  significantly from the specified value, the stator may  (s) to the mounting bracket.
                                need to be replaced.


                                            AC VOLTAGE (VAC)
                       RPM READING
                                                 READING
                            1300               24 VAC ± 25%
                            3000               50 VAC ± 25%

                            5000               82 VAC ± 25%








                                                                     5. Install new regulator(s) on the bracket. Torque
                                                                        fasteners to specification.
                                                                                          TORQUE
                                                                                     Regulator Fasteners:
                                                                                        8 ft-lb (11 Nm)



                12.22                                                      9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
                                                                                                © Copyright Polaris Industries Inc.
   553   554   555   556   557   558   559   560   561   562   563