Page 568 - Manual_Polaris_RZR_ProXP-20-21

ELECTRICAL

7. Remove two large hoses e and vent line r from the INSTALLATION
radiator.
1. Install the fan and radiator as an assembly.
2. Connect fan harness.
3. Install two fasteners retaining fan assembly. Torque
fasteners to specification.

TORQUE
Fan Assembly Mounting Fasteners:
9 ft-lbs (12 Nm)

4. Connect the two coolant hoses and one vent line
going to the radiator.

5. Install the charge air radiator into the chassis.
6. Install the two large hoses going to the charge air
radiator and the small vent hose.
8. Cut zip ties retaining vent line to the fan shroud.
7. Install the radiator shroud and install six push pins.
9. Remove two fasteners t retaining the fan assembly
to the vehicle. 8. Install voltage regulator bracket and voltage
regulators as an assembly. Install two fasteners and
torque to specification.
TORQUE
Voltage Regulator Bracket Fasteners:
7 ft-lbs (10 Nm)

9. Connect four voltage regulator harness connectors
(two per voltage regulator).
10.Install front fascia.
TORQUE
Front Fascia Fasteners:
7 ft-lbs (10 Nm)
10.Disconnect the electrical connector to the fan.
11. Fill the cooling system. Properly bleed both the
11. Pull upward on the fan to disconnect the assembly
from its lower mounting grommets. Remove fan and engine cooling system as well as the charge air
radiator as an assembly. cooling system. See Cooling System Bleeding page
2.38.

12.Remove cooling fan from radiator.

12.32 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.