Page 157 - Manual Oficina XP 1000 14-16
P. 157
ENGINE / COOLING SYSTEM
7. Install and finger tighten the two outer M6 bolts y CAMSHAFT INSTALLATION / TIMING
evenly.
NOTE
NOTE
If any valve train components were replaced, refer to
Install new cylinder head bolts. Valve Clearance Adjustment, page 3.84 procedure prior
to Camshaft Installation / Timing, page 3.79.
8. Torque cylinder head bolts in sequence to
specification. 1. Rotate the engine until the flywheel Top Dead Center
(TDC) mark q is aligned or centered in the
Crankshaft Position Sensor (CPS) mounting hole w.
This places the PTO cylinder at TDC for camshaft 3
installation.
TORQUE
Cylinder Head Torque Procedure:
Torque in sequence
Step 1: 9 ft-lbs (12 Nm) NOTE
Step 2: 26 ft-lb (35 Nm) DO NOT use the “V” mark located on the flywheel
Step 3: Additional 180° opposite of the “I” mark. Only the “I” mark should be
used as a TDC reference.
Step 4: M6 bolts: 7 ft-lb (10 Nm)
2. Reference the intake and exhaust markings made
during disassembly. If installing new camshafts or if
camshafts were not marked, you can reference the
part number stamped on the end of the shafts and
compare to the electronic parts catalog.
3. Lubricate all camshaft lobes and bearing journal
surfaces with Polaris PS-4 engine oil prior to
installation.
9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 3.79
© Copyright Polaris Industries Inc.
