Page 155 - Manual Oficina XP 1000 14-16

ENGINE / COOLING SYSTEM

ENGINE ASSEMBLY - TOP END

CYLINDER HEAD ASSEMBLY 6. Install the valve spring with widely spaced coils y on
the top and tightly spaced coils u facing down
NOTE toward the cylinder head.
Assemble the valves one at a time to maintain proper
order.

WARNING

Wear eye protection during cylinder head disassembly 3
and reassembly or when working with the valve springs.

1. Apply engine oil to valve guides and seats.
2. Coat valve stem with Premium Starter Grease (PN
2871460).

3. Install the valve q in the cylinder head, through the
guide.

NOTE

Valve springs to be installed with paint mark facing up
i.

7. Place the valve retainer on the spring.
8. Compress the valve spring by hand using valve
spring compressor adapter (PV-43513-A). Compress
spring only enough to allow split keeper installation.
Valve spring compressor (PV-1253 or PV-4019
(Quick Release)) can be used if desired to aid in
installation.

4. Dip the new valve seat/seal w in clean engine oil
and carefully install the valve seat/seal on the valve
guide with a rotating motion. Push firmly until seated
in retaining groove and square with the guide
NOTE
Valve seals should be installed AFTER the valves are in
the head to avoid valve seal damage.

5. Dip the valve spring e and retainer r in clean
engine oil.

NOTE
To prevent damage to the valve seals, do not compress
the valve spring more than necessary to install the
keepers.

9. Install split keepers t with gap even on both sides.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 3.77
© Copyright Polaris Industries Inc.