Page 272 - Manual Oficina XP 1000 14-16

TRANSMISSION

SHIFT LEVER / CABLE

SHIFT LEVER REMOVAL SHIFT LEVER INSTALLATION
1. Remove the shift knob cover q, retaining screw w Perform the removal steps in reverse order to install the
and shift knob e from the shift lever r. gear shift lever (lever, cable, console, shift knob).

SHIFT CABLE INSPECTION

Shift cable adjustment may be necessary if symptoms
include:
• No gear position or AWD display on instrument cluster
• Ratcheting noise on deceleration
• Inability to engage into a gear
• Excessive gear lash (noise)
• Gear selector moving out of desired range

Inspect shift cable, clevis pins, and pivot bushings and
replace if worn or damaged.

SHIFT CABLE ADJUSTMENT
1. Locate the shift cable attached to the transmission
2. Remove the fasteners retaining the center console case in the right rear wheel well area.
(see Body / Frame chapter). Remove the console 2. Inspect shift cable q, clevis pin, pivot bushings, and
from the vehicle.
dust boot w. Replace if worn or damaged.
3. Remove the clip and washer retaining the shift cable
to the shift lever and disconnect the cable end from
the lever.
4. Remove the retaining ring t and slide the shift lever
y off the mounting bracket and out from the frame.

5. Remove both bushings u from the shift lever and
service as needed.

6.4 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.