Page 277 - Manual Oficina XP 1000 14-16

TRANSMISSION

TRANSMISSION INSTALLATION 5. Install the two rear exhaust springs securing the
muffler to the rear transmission mounting bracket.
1. With the help of an assistant, position the
transmission into the vehicle frame through the left 6. Install the Clutch Center Distance Tool onto the
rear wheel well area. crankshaft and transmission input shaft to properly
position the clutch center distance.
2. Slide transmission towards rear of the vehicle and
rotate the top of the transmission toward the right side Clutch Center Distance Tool:
of the vehicle. PU-50658-A

IMPORTANT
Tool should bottom out on the transmission input shaft
and lay flush on the crankshaft.

7. Loosen the two bolts retaining the transmission
coupler bracket to the engine on the right side.

3. Install the rear transmission mount to the frame and
secure with M8 bolts and nuts. Torque nuts to 6
specification.

8. Align front transmission mounting holes with
transmission joint bracket mounting holes on engine.
9. Loosely install the two longer bolts into left side
mounting holes and two shorter bolts with washers
into right side mounting holes.

NOTE
DO NOT torque fasteners at this time.

TORQUE
Rear Transmission Mount Bracket Fasteners q:
17 ft-lb (23 Nm)

4. Install M10 bolt and nut securing the transmission
bracket to the rear mount. Torque fasteners to
specification.
TORQUE

Rear Transmission Isolator Fasteners w:
40 ft-lb (54 Nm)

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 6.9
© Copyright Polaris Industries Inc.