Page 275 - Manual Oficina XP 1000 14-16

TRANSMISSION

7. Remove the four bolts (w attaching the upper and 11. Remove the gear position switch connector y, speed
lower radius rods to the bearing carriers (left and right sensor connector t, crankshaft position sensor
side). Discard nuts and replace with new upon connector r, shift bracket bolts and shift bracket u,
assembly. Allow the radius rods swing downward. shift cable clevis pin and washer i from the
transmission.

8. Lift training arms up and swing trailing arms outward
to remove the drive shafts from the transmission. 12.Remove the wire ties retaining harness to
transmission and mounts.
9. Maneuver the drive shafts out of the vehicle frame.
Reinstall the lower shock bolts e to hold the trailing
arms up during the rest of the removal procedure. 6

13.Place a spacer or support between the vehicle frame
and engine to hold the engine up in position or
support the engine from the top side using an
10.Remove vent hose from transmission. overhead lift.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 6.7
© Copyright Polaris Industries Inc.