Page 331 - Manual Oficina XP 1000 14-16
P. 331
FINAL DRIVE
4. Once the front and rear prop shafts have been REAR PROP SHAFT INSTALLATION
separated, slide the rear prop shaft forward to 1. Reverse the appropriate “Rear Prop Shaft Removal”
remove it from the transmission output shaft. procedure to reinstall the rear prop shaft.
2. Lubricate the transmission output shaft splines with
Polaris All Purpose Grease.
3. Lubricate the front and rear prop shaft mid joint with
Polaris All Purpose Grease.
4. Slide the rear prop shaft forward from the left rear of
the machine just below the PVTcover. Install the rear
prop shaft on the transmission snorkel shaft.
5. Lubricate the support bushing with light oil to ease
installation and install the bushing on the rear prop
shaft bearing.
6. Align the front and rear prop shafts as shown below
and slide them together.
5. Remove the support bearing rubber bushing by
pulling it off the rear prop shaft.
6. Remove the rear prop shaft out of the left rear of the
vehicle.
7
NOTE
Paint marks are applied to the front and rear prop shafts
to aid shaft alignment. Reference these marks during
installation if still visible.
9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 7.29
© Copyright Polaris Industries Inc.
